SineDigital,Inc.
Installation Guide for MW-1500AP(H)
Entire contents 2003
SineDigital,Inc
.
All rights reserved
Page 14
aaa auth ip<number> <IP address>
: Defines the RADIUS authentication server's IP
address. An example would be "aaa auth ip1 10.0.0.3".
aaa auth port<number> <port number>
: Defines the RADIUS authentication server's port
number. An example would be "aaa auth port1 1812".
aaa auth secret<number> <name>
: Defines the shared secret name to be used with the
RADIUS authentication server. An example would be "aaa auth secret1 test".
aaa auth retry <number>
: Defines how many times upon failure the MW-1500AP(H) will
retry connection with the RADIUS authentication server. An example would be "aaa auth
retry 3".
aaa auth timeout <sec>
: Defines the time span (in seconds) in which the MW-1500AP(H)
will try to connect with the RADIUS authentication server. An example would be "aaa auth
timeout 5".
aaa auth nas_id <name>
: Defines the MW-1500AP(H)'s NAS Identifier, which is the name
that the RADIUS server will see. An example would be " aaa auth nas_id MMC-WL-
AP1500".
aaa acct [enable / disable]
: Enables/disables client accounting management by the MW-
1500AP(H).
aaa acct ip<number> <IP address>
: Defines the RADIUS accounting server's IP address.
An example would be "aaa acct ip1 10.0.0.3".
aaa acct port<number> <port number>
: Defines the RADIUS accounting server's port
number. An example would be "aaa acct port1 1813".
aaa acct secret<number> <name>
: Defines the shared secret name to be used with the
RADIUS accounting server. An example would be "aaa acct secret1 test".
aaa acct retry <number>
: Defines how many times upon failure the MW-1500AP(H) will
retry connection with the RADIUS accounting server. An example would be "aaa acct retry
3".
aaa acct timeout <sec>
: Defines the time span (in seconds) in which the MW-1500AP(H)
will try to connect with the RADIUS accounting server. An example would be "aaa acct
timeout 5".
aaa acct interim <sec>
: Defines the cyclic time period after which the MW-1500AP(H) will
send each client's accounting information to the RADIUS accounting server (i.e. the interim
interval). There are three possible types of values you can assign for the interim value:
-1
: Setting it to -1 (negative one) will have the MW-1500AP(H) not send out clients'
accounting information to the RADIUS accounting server.
Zero (0)
: In case the RADIUS accounting server does not specify a interim interval, the
MW-1500AP(H) will send the client's accounting information to the RADIUS accounting
server only once when the client logs-in and then once again when the client logs-out.
However, if the RADIUS accounting server specifies a interim interval, the MW-
1500AP(H) will send clients' accounting information to the RADIUS accounting server
according to that specified time value.
Positive (+)
: You may define the interim interval manually to any positive value from 60 to
2,147,483,647 seconds (you must input without the commas).
aaa pod [enable / disable]
: Enables/disables operation of the MW-1500AP(H)'s POD
function (refer to chapter 3.2.3.12).
