SineDigital,Inc.
Installation Guide for MW-1500AP(H)
Entire contents 2003
SineDigital,Inc
.
All rights reserved
Page 22
(14) redirect
This command is only applicable when operation of the MW-1500AP(H)'s 802.1x function is
enabled. The redirect function allows either or both of the following functions to operate:
Just Enrollment
: Redirection of client that either fails authentication or tries to access the
Internet without authenticating to a specified homepage.
Just First Browsing
: Redirection of client to a specified homepage right after successfully
passing authentication.
The above can also be used in combination.
Typing the command
redirect
at the prompt, you will be presented with the
redirection menu
,
where you will be able to configure its parameters by entering the number of your choices.
AccessPoint> redirect
---------------------------
REDIRECTION MENU
---------------------------
1. Show Current Setting
2. Set New Configuration
3. Flush IPs for Redirect URLs
4. Use Private IP for Redirection
---------------------------
Enter the Index of MENU : 2
---------------------------------------------
REDIRECTION MODE
---------------------------------------------
Index Just Enrollment Just First Browsing
---------------------------------------------
[1] OFF OFF
[2] ON OFF
[3] OFF ON
[4] ON ON
---------------------------------------------
Enter the Index ? 2
Enter the new URL : http://www.mmctech.com
More Sub-Server IP ? (y/n)
"write config" and "reboot" to confirm
AccessPoint>
The figure above illustrates the configuration of the redirection function using the command
redirect
. In case redirection will be done to multiple homepages, enter
Y
to the prompt "
More
Sub-Server IP? (y/n)
" (You can enter up to four different homepages).
