SineDigital,Inc.
Installation Guide for MW-1500AP(H)
Entire contents 2003
SineDigital,Inc
.
All rights reserved
Page 11
3. Configuration And Management Via Console Commands
Console commands are used to control the MW-1500AP(H)'s configuration and management
functions when you link with the MW-1500AP(H) directly via a serial cable.
You will need to use console commands mostly when you first set-up your MW-1500AP(H) for
your particular network or when something happens that prevents you from communicating with
the MW-1500AP(H) remotely.
The following will show you how to establish a wired connection between your PC and MW-
1500AP(H), followed by some of the most significant console commands.
Your screens may be different from the screens used at the time of this manual's writing
according to the firmware version you are actually using.
Establishing A Console Link With The MW-1500AP(H)
Step 1: In order to access the MW-1500AP(H) via its console port, you will need a RS-232
serial cable (crossed) with the following connector pin arrangement:
PC side: DB-9
(female)
AP side: DB-9
(male)
Pin No. 2
Pin No. 3
Pin No. 3
Pin No. 2
Pin No. 5
Pin No. 5
Step 2: Connect the PC side of the RS-232 serial cable into the PC's serial port (refer to your
PC's manual). The other end of the RS-232 serial cable should be connected into the MW-
1500AP(H)'s console port (labeled "COM").
Step 3: On the PC, run a terminal emulation program (e.g. Windows HyperTerminal) and
configure it to the following values:
> Bits per second : 57600
> Data size : 8
> Parity : none
> Stop bits : 1
> Flow control : none
