Simrad SL 30, Руководство пользователя

Страница: 73 / 224

SL 30/35 Hull Sonar Operators Manual 974-25007001/2.0
Menu and Software Description Page 4.27
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
•
Click on the Magnetic Variation tab to open the Parameters Magnetic Variation
page
•
Enter the local magnetic variation. This information is available on marine charts
of the area. Click the OK button
•
To setup the system to display heading data from a compass:
•
Configure the system to accept compass data as above
•
In the View menu, select Sensors
•
Select Sensors in the Configuration Menu to open the Sensors Configuration
Sensors Selection page
•
Select HDG in the Standard list then click the Connect button below this list. An
icon for the HDG sentence will appear under the selected COM port icon. Note:
You can also use HDT or HDM if your compass does not support the HDG
sentence
•
Click the Ports Configuration tab to open the Sensors Ports Configuration page
•
Click on the COM port icon that you are using for the compass
•
Click the Use NMEA Settings button. Note: This will set the Bits Per Second
(Baud rate) to 4800. If your compass uses a different rate, set the Bits Per
Second accordingly
•
Click the OK button
If you are using a magnetic or fluxgate compass (not a true gyro compass) you
should enter the local magnetic variation in the following steps:
•
Select the communication (COM) port you want to use for the compass by
clicking on the desired COM port icon
4.38 HOW TO SETUP FOR AND DISPLAY OTHER NMEA DATA
To setup the system to accept data from an NMEA device:
•
Select Sensors in the Configuration Menu to open the Sensors Configuration
Sensors Selection page
•
Select the communication (COM) port you want to use for the NMEA device by
clicking on the desired COM port icon
•
Select a sentence in the Standard list that is supported by your NMEA device,
then click the Connect button below this list. An icon for this sentence will
appear under the selected COM port icon