Simrad SL 30, Руководство пользователя

Страница: 163 / 224

SL 30/35 Hull Sonar Operators Manual 974-25007001/2.0
Installation, Start-Up and Test Page 6.15
Kongsberg Simrad Mesotech Ltd.
Port Coquitlam, BC - Canada
start up automatically. A green LED will light up indicating that power has been
applied and no
Alarms have been detected
•
Next, press the Down Transducer Arrow button to lower the sonar dome into its
position. The middle yellow LED will blink while the sonar dome is lowering. The
lower green LED will light and remain illuminated when the sonar dome has
reached the full down position
•
Next, go to the Paragraph 6.6.4 “Run UP” procedure.
Note: If the SL 30/35 processing unit or the control / interface unit were replaced
after the initial installation, you will have to re-do the “Power UP Configuration”
located in the next Paragraph 6.6.2
6.6.2 Power-Up Configuration
For the system to operate properly, the SL 30 or SL 35 configuration must be
selected correctly. In addition, modification of these power-up configuration
parameters is done in a special mode selected after the power-up of the processor
unit.
The following sections describe the process of configuring these parameters. These
steps must be followed only when the system is powered-up for the first time or when
you have to replace the processing unit or the interface unit assembly.
6.6.3 SL 30 or SL 35 Start up Procedure
For the purpose and demonstration on the Start-up Procedure in this chapter, we
are using an HP/PC processing unit that has a COM 1 and a COM 2 port, Dual
SVGA monitor output, Sound card and one Network LAN port. We will be using a
dual sonar System, one SL 35, 90kHz sonar and one SL 30, 160kHz Sonar dome
with motion sensors
The first step after a successful power up is to configure the system for the desired
“User Setting” operating mode and set-up, if not already done; you will automatically
select “Generic”. Clicking on “Generic” or clicking on specific Users or types of
fishery.