Simrad ARGUS FMCW 3G, Руководство пользователя

Страница: 145 / 150

| 143
ARGUS FMCW radar | Argus Radar Operator Manual
X
The zone relative to the two virtual transceivers has been highlighted by the red box. In fact,
both are identified as FMCW 2 and A and B are assigned to distinguish them internally. The
data visualized immediately above refer to range B (second service) and pressing the X push
buttons the system passes to range A.
Assignment of a name to the transceiver - D
In box
D
a name can be assigned to the analyzed transceiver to identify it easily in the list of
possible selections that are presented in the Interswitch menu (see “TXRX interswitch menu
(standard)” on page 77), for example stern or bow identify the position of the transceiver on
the ship.
Scales - E
In box E the transceiver can be assigned two types of Unit of Measurement depending on
user requirements. These types are:
• Feet
• Metres
These Units of Measurement will only be utilized at low scales (under 1/8 NM).
Alignment of the Heading Line - F
In box F the heading line can be alignment so that the image can be rotated in the right
direction.
Transceiver parameters - G
In box G the data relative to the selected transceiver can be visualized (Serial number, DID, IP
Address, etc.). These parameters cannot be modified by the user because they belong to the
FMCW transceiver radar system.
Transceiver position - H
In box H a precise position can be assigned to an FMCW transceiver that will be utilised in the
list of possible selections in the Interswitch menu. Initially, each console will give a position
automatically depending on the response times of the FMCW. These positions might not be
the same on every console present in the system, therefore a check and any successive manu-
al setting is recommended in order to obtain a coherent configuration on each console.
Transceiver selection - I
The line I is highlighted in the transmitter on which we are changing.
Utilization of the FMCW transceiver radar system
How to use the FMCW transceiver radar system is explained in this paragraph and also the
various functions of the pushbuttons that appear in the window relative to the transceiver.
Selection of the FMCW transceiver on additional PPI
From the Main menu (“Main menu” on page 43), press the “TXRX AND INTERSWITCH MENU”
button (“Interswitch menu with FMCW transceivers” on page 144). In the primary PPI up to 4
transceivers can be selected, but using additional PPI up to 16+4 transceivers can be selected.
Even if the page shows only 4 at a time, using the “Prev” and “Next” arrow buttons (“Interswitch
menu with FMCW transceivers” on page 144 - position A), all transceivers on the ship can be