GB
8
Problem
Possible cause
Solution
Red LED does not illuminate to
indicate the Battery (5) is cor-
rectly charging
Battery not correctly connected to Charger (8)
Clean battery socket of Battery Charger (8) and Battery
contacts and fully slide on to Charger
Battery Charger not powered
Recheck mains connection
Battery pack has low capacity
Battery not being fully charged
Do not remove Battery from the Battery Charger
until a full charge is indicated
Battery pack has been charged over 100 times
and capacity has started to reduce
This is normal for battery packs. Contact your Silverline
dealer to purchase a replacement battery pack
Impact drill cannot be switched
’ON’ (Trigger Switch (13) does
not move)
The Forward/Reverse Switch (3) may be in
the middle (‘locked’) position (Fig. IV)
Slide the Forward/Reverse Switch to the forward or reverse
positon, see ‘Direction control’ section
Impact drill does not start when
Trigger Switch is depressed
Battery completely discharged
Recharge battery or replace with a fully charged battery
Defective Battery
Replace Battery
Tool defective
Contact your Silverline dealer or authorised service centre
Troubleshooting
578256_Manual.indd 8
16/11/2017 11:10
