SIKA, Dr. Siebert & Kühn GmbH & Co. KG, Struthweg 7-9, 34260 Kaufungen, Germany
33/40
Tel: +49-5605-803-0, Fax: +49-5605-803-54, email: [email protected], web: www.SIKA.net
Cyclic ramp configuration?
The figure below illustrates the type of single ramp that can be generated and their parameters:
The
LOW level
and
HIGH level
levels are expressed:
•
As a percentage of the gauge if the scaling mode is ON.
•
In Volt or in temperature units if the scaling mode is OFF and according to the type of value emitted
(voltage or temperature emission).
The
Low Duration
,
Rise
,
High Duration
,
Drop
and
Time frame
durations are expressed in seconds. The max
duration is limited to 1000s.
The
Repetitions
field indicates the number of ramps that need to be generated. The number of repetitions is limited
to 1000.
Use the
F2
key to access the
CONFIGURATION/RAMP
menu. Attention: the appropriate function mode must be
programmed (
Single Ramp
mode) to access the
CONFIGURATION/RAMP/CYCLIC RAMP
menu.
In the
CONFIGURATION/RAMP/CYCLIC RAMP
menu, use the
F2
key to go to the next field.
Use the navigation keys to enter the value:
•
As a percentage of the gauge if the scaling mode is ON.
•
↑
↑
↑
↑
and
↓
↓
↓
↓
to increase or decrease the value
•
and
to choose the hundreds/tens/units/decimal place/hundreds/thousands.
Press
VAL
to save the parameters.
To quit the menu without saving, press
CLEAR
.
Programming parameters in
Cyclic ramp
mode
T0
NH
NB
Td
Tb
Tm
Th
Tf
To : time pressing generation start key
Td :
Time frame
Tb :
Low duration
Tm :
Rise
(rise time)
Th :
High duration
Tf :
Drop
(drop time)
NB :
Low Level
NH :
High Level
