Signode SLP-12, Руководство по эксплуатации, частям и безопасности

Страница: 32 / 35

32
CHANGING SLP STRAP SIZE
The following table illustrates the unique
parts to a particular strap size for the SLP
tool. If the strap size of the tool is to be
changed, this table must be used to
coordinate all the respective parts which
must be replaced.
Do not attempt to convert a tools strap
size without replacing all of the
specified parts for the conversion.
Failure to replace all required parts
may cause severe personal injury.
UNIQUE PARTS TO SLP STRAP SIZES
KEY QTY DESCRIPTION SLP-38 SLP-12 SLP-58 SLP-34
32 1 Nameplate 422652 422185 422184 422183
60 3 Cutting Insert 422059 422749
66 1 Inner Guide 422653 422353 (Rotate as required.)
71 1 Punch 422058 422748
72 1 Strap Guide,
Front 422392 422177 422176 422175
73 1 Strap Latch 422771 422684 422683 422768
91 1 Strap Guide 422776 422746 (Rotate as required.)
119
&
120 STRAP TENSION
Adjust as required,
review page 12. LOW
(400 Lbs.)
LOW
(500 Lbs.)
STANDARD
(1200 Lbs.)
123 1 Tension Motor 424170 424150
NOTE: An SLP-38 Tool can be converted from any standard SLP-12 by
ordering the SLP-38 Conversion Kit (Part No. 422399).
For Parts & Service 1-877-862-6699
WWW.TRADITIONALTOOL.COM