30
TROUBLESHOOTING
The following items are the most common tool symptoms if problems occur. For symptoms or
remedies not shown, contact your Signode service representative for additional information and
details. The following tool symptoms are shown in this manual:
#1 - Difficult strap slack removal.
#2 - Bottom strap pulls out while loading strap.
#3 - Tool does not tension when tension lever is pressed.
#4 - Strap tension is too low or too high
#5 - Tool does not complete sealing cycle.
#6 - Strap does not cut after sealing cycle.
#7 - Bottom strap breaks during sealing.
#8 - Tool cannot be removed from strap after completion of strap cycle.
#1 SYMPTOM: Difficult strap slack removal.
CAUSE
REMEDY
1.
Improper strap being used.
2.
Worm wheel mechanism worn or
broken.
1.
Check that waxed strapping of the
correct width is being used.
2.
Repair or replace worm wheel
components.
#2 SYMPTOM: Bottom strap pulls out while loading strap.
CAUSE
REMEDY
1.
Improper strap being used.
2.
Feedwheel clearance incorrectly set.
3.
Dirty or worn clutch plug.
1.
Check that waxed strapping of the
correct width is being used.
2.
Check feedwheel clearance, adjust if
necessary.
3.
Clean or replace clutch plug as
required.
#3 SYMPTOM: Tool does not tension when tension lever is pressed.
CAUSE
REMEDY
1.
Improper strap being used.
2.
Feedwheel clearance incorrectly set.
3.
Dirty or worn feedwheel.
4.
Straps improperly aligned.
5.
Feedwheel not rotating.
1.
Check that waxed strapping of the
correct width is being used.
2.
Check feedwheel clearance, adjust if
necessary.
3.
Clean or replace feedwheel as required.
4.
Reload and realign straps.
5.
Inspect gear housing for broken parts.
For Parts & Service 1-877-862-6699
WWW.TRADITIONALTOOL.COM
