20
GB
I
2.3 SPECIFICHE AMBIENTALI
L’operatività della vetrina viene garantita in condizioni
ambientali:
- Temperatura di 25°C
- Umidità relativa di 65%.
Inoltre nell’installare della vetrina si devrà verificare
che (n°7):
-Vi sia una sufficiente circolazione d’aria intorno alla
vetrina, ma che non vi siano forti correnti;
- Non la si deve posizionare nelle vicinanze di sorgenti
di aria calda;
- Non deve essere esposta direttamente alla luce del
sole;
- Non devono essere ostruite le griglia per il passaggio
dell’aria di raffreddamento del condensatore;
- Non venga indirizzata sulla vetrina l’eventuale aria
condizionata o di riscaldamento del locale .
ATTENZIONE!
E’ essenziale rispettare le indicazioni suddette
per evitare malfunzionamenti, che non saranno
coperti da garanzia.
2.4 POSIZIONAMENTO
Una volta posizionato nella zona desiderata e regolata
l'altezza dei piedini rimuovere i due listelli prima di dare
il posizionamento definitivo. La rimozione dei listelli si
effettua nel seguente modo:
- svitare le viti (n° Pos.A) delle piastre di ancoraggio
(n° Pos.B);
- sollevare di nuovo la vetrina;
- togliere i due listelli di legno (n° Pos.C).
- abbassare la vetrina a terra, posizionarlo nella zona
voluta, avendo cura di coprire il piedino con l'apposita
copertura (n° Pos.d).
2.3 AMBIENT CONdITIONS
The display unit is guaranteed to function in the follow-
ing ambient conditions:
- Temperature: 25°C
- Ambient R.H.: 65%
Furthermore, during the installation process, check the
following (n°7):
- That there is sufficient air circulation around the display
unit but that there are no strong draughts;
- That the unit is not installed near to sources of hot
air;
- That the unit is not exposed to direct sunlight;
- That the air passage grilles for condenser cooling are
not obstructed in any way;
- That any air conditioning or heating systems are not
directed towards the display unit.
CAUTION!
It is essential to respect the above indications if
malfunctions not covered by the Guarantee are
to be avoided.
2.4 POSITIONING
Once the unit has been positioned as required and
the feet heights have been adjusted, remove the two
wooden strips before fixing the unit definitively into
place. The wooden strips are removed as follows:
- Loosen the screws (Pos.A, n°) of the anchorage plates
(Pos.B, n°);
- Lift the display unit from the ground;
- Remove the two wooden strips (Pos.C, n°);
- Lower the unit and position as required, making sure to
cover each foot with the shield provided (Pos.d, n°).
n°7
Содержание 1250
Страница 2: ......
Страница 52: ...52 GB I TAV 1 SCHEMA ELETTRICO TAVOLA FREDDA 220 V ...
Страница 54: ...54 GB I TAV 2 SCHEMA ELETTRICO TAVOLA FREDDA CON ILLUMINAZIONE 220 V ...
Страница 56: ...56 GB I ...