Sierra Wireless MP 700 Series, Справочник по командам

Страница: 45 / 118

Command Reference
Rev 3.2 Oct.05 43
!MPGPSCOMOUT
(continued) Enable GPS output to the AT command port (continued)
The
<enable>
and
<save to NV>
parameters have this effect:
<enable>=0, <save to NV>=0
GPS data is NOT sent to the COM port.
When the modem is reset, GPS data will
be sent or not, based on the previously
saved <enable> setting. (If no setting has
been previously saved, GPS data will
NOT be sent to the COM port.)
<enable>=0, <save to NV>=1
GPS data is NOT sent to the COM port.
When the modem is reset, GPS data will
NOT be sent.
<enable>=1, <save to NV>=0
GPS data is sent to the COM port. When
the modem is reset, GPS data will be sent
or not, based on the previously saved
<enable> setting. (If no setting has been
previously saved, GPS data will NOT be
sent to the COM port.)
<enable>=1, <save to NV>=1
GPS data is sent to the COM port. When
the modem is reset, GPS data will
continue to be sent.
!MPGPSDATA? Report current GPS data
This returns a parsed string:
Valid Flag Used internally to verify data.
LED Status of the GPS LED on the front panel of the modem:
1 Off
2 On flashing
3 On solid
Receiver St1 & Status Byte 1 and Status Byte 2
Receiver St2 As returned by the TAIP command, >QST<. The codes
indicate the operational status of the GPS module. (TAIP
command documentation is available on the Trimble and
Sierra Wireless web sites. See
!MPGPSCMD .)
Continued on next page.
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description