Siemens SITRANS FUH1010PVX, Руководство по эксплуатации, Страница: 61 / 226

1-33
1010BXFM-3 Section 1
z
Type digit 9 and then press <ENTER>. Next, move the highlight to [Wall Thickness]. Press
the <Right Arrow>, type 0.29, and then press <ENTER>. The [Pipe Data] screen will show
these changes as seen below.
1.17.3 HOW TO SELECT A LIQUID TYPE
Next, we will select a liquid type. Liquid selection is optional. However, selecting a liquid
makes it more likely that the meter’s initial transducer spacing recommendation will be valid.
In addition, it allows the meter to adjust its flow profile compensation curve to the viscosity of
the liquid. You do not have to find the exact liquid on the option list. Picking a liquid with
similar characteristics is sufficient. The default selection is Water @ 20°C/68°F. For this ex-
ample we will select [Diesel Fuel]. Press the <Left Arrow>, then press <Down Arrow> to
[Application Data]. Press the <Right Arrow> to access the [Application Data] menu. Note that
the menu cell [Liquid Class] is highlighted and the default selection [Water 20C/68F] appears
in the right-hand column.
Controlotron Site [1] SITE1
Enter pipe Outer Diameter manually
Pick Pipe Class Manual Entry
Select Pipe Size N/A
Pipe OD <in> =0.500
Pipe Material Steel
Wall Thickness 0.100
Liner Material None
Liner Thickness 0.000
Pipe Data
Controlotron Site [1] SITE1
Identify Liner material for Lined Pipes
Pick Pipe Class Manual Entry
Select Pipe Size N/A
Pipe OD <in> 9.000
Pipe Material Steel
Wall Thickness 0.290
Liner Material None
Liner Thickness 0.000
Pipe Data
Controlotron 2 Channel [1] SITE1
Select Liquid Class from Liquid Table
Liquid Class Water 20C/68F
Liquid Table
Temperature Range
-40F to 250F
Pipe Config Fully Developed
Anomaly Diams 10
Application Data
Siemens Hardware