Siemens SITRANS FUH1010PVX, Руководство по эксплуатации, Страница: 125 / 226

2-59
1010BXFM-3
Section 2
Clr Saved Data? Response to pressing F4 key, then selecting [No] for Clr Saved Data?
<EOT> Response to a request to output datalogger data to the printer or the
Graphics screen when no datalogger data exists. Set up the Datalog-
ger.
Empty Pipe - Press Prompt to empty the pipe during the Actual MTY procedure. After
[ENT] emptying pipe, press <ENT>.
Fill Pipe - Press [ENT] Prompt to fill the pipe during the Actual MTY procedure. After
filling the pipe, press [ENT].
No Sites Response while trying to recall/delete a site setup when no Sites
are stored.
Not Installed Response to an attempt to access a menu function that is not in-
cluded.
Re-space Index Upon measuring the liquid sonic velocity (Vs), the meter recom-
mends re-spacing the transducers to improve performance.
Invalid Setup During the Initial Makeup, the system detects invalid transducer spac-
ing, erroneous liquid/pipe parameters, or some other factor that pre-
vents it from completing the Initial Makeup. This may be due to one of
the following:
• An out-of-range data entry.
• An invalid condition; (e.g. overlapping transducers in Reflect Mode).
If selecting Direct Mode does not resolve, review all site setup and
transducer installation choices; particularly data entered for the pipe
and liquid.
• In Reflect Mode, the flow computer detects that the pipe wall signal
may infringe upon the liquid signal. Use Direct Mode instead.
Press <ENT>, <UP Arrow>, <DOWN Arrow>, or <LEFT Arrow> to
abort install routine. Continue programming other site data in antici-
pation of resolving the difficulty later. Call technical support for help
if necessary.
Low Signal - During the Initial Makeup, the meter decides that the level of the
receive signal is insufficient for proper operation. Some reasons for a
low signal are:
• Invoking [Install Completed?] on an empty pipe.
• Coupling compound insufficient, not applied, or evaporated.
• A disconnected or broken transducer cable.
• You need to condition the pipe at the mounting location.
• A large air bubble needs to be “flushed out”.
• The Xdcr cables are defective or not connected to the correct chan-
nel.
• The Set Empty routine performed when pipe was NOT actually
empty.
If you locate and correct the improper condition immediately, press
<ENT> to resume the installation procedure. Otherwise, press the
<Left Arrow> to abort the installation and conduct a thorough inves-
tigation.
(use Direct Mount)
MESSAGE DESCRIPTION
(continued)
Press [ENT]
Siemens Hardware