Siemens SIRIUS 3RW51, Руководство по эксплуатации оборудования

Страница: 81 / 210

6. Change the setting of the selected parameter using the RESET / TEST key.
You can recognize your selection by the color combination of the three LEDs RN, ER and MT.
Setting the parameter "Control via digital input" (selection in Step 1):
Control via digital input / response to bus errors
"RN" LED "ER" LED "MT" LED Set parameter value
Off Off Off
Manual activation
Off Off
Lights up yel‐
low
Permanent activation
Off
Lights up red Lights up yel‐
low
Activate on bus error (factory setting)
Lights up green Lights up red Lights up yel‐
low
No change on bus error
Setting of the parameter "Output ON / RUN" (selection in Step 1):
Output ON / RUN
"RN" LED "ER" LED "MT" LED Set parameter value
Off Off Off
Output function ON
Off Off
Lights up yel‐
low
Output function RUN
7. Switch off the power supply (control supply voltage) of the 3RW51 soft starter for at least
5 seconds.
The set parameters and parameter values are stored.
8. Switch on the power supply (control supply voltage) of the 3RW51 soft starter again.
The set parameters and parameter values are now active.
Further parameterization options
• 3RW5 HMI High Feature (accessory)
– Menu: "Parameters > Soft Starter > Additional parameters > Control via digital input"
(3RW5 HMI High Feature with firmware version V3.0 and higher)
– Menu: "Parameters > Soft Starter > ON / RUN relay output"
• Procedure in chapter Parameterizing output 13 / 14 (Output signal ON or RUN) (Page 78)
Parameter assignment
6.8 Parameterize the response to bus errors and output 13, 14 (ON /
SIRIUS 3RW51 Soft Starter
Equipment Manual, 09/2020, A5E37108631002A/RS-AC/003
81