Siemens SIRIUS 3RW51, Руководство по эксплуатации оборудования

Страница: 106 / 210

Key Actions
/2&/
5(07
• Changes master control
LOCL means that the 3RW5 HMI Standard is the master control.
REMT means that the 3RW5 HMI Standard is not the master control.
• Locking switch Locked / Unlocked:
To be able to operate the 3RW51 soft starter with the 3RW5 HMI Standard, the locking switch
on the rear of the 3RW5 HMI Standard must be unlocked. If the locking switch on the rear
of the 3RW5 HMI Standard is in the "Locked" switch position, the "RESET / TEST", "LOCL /
REMT" and "Start" and "Stop" keys are disabled. Navigation through the menu using the
navigation keys, however, is still possible.
8.11.2 3RW5 HMI Standard menu
The following information is shown on the display of the Standard HMI module:
• Operating state
• Measured values
• Parameters
While you are setting the parameters, the actual value is shown in the display.
• Diagnostics
Operating state
Display Explanation
STATE
ON
STATE
The ramp-up time comes to an end and the motor is running.
RAMP
STATE The ramp-up time or the stopping time is active.
OFF
STATE
The motor is switched off.
ER O
STATE
The motor is not ready to start because there is a fault.
Additional information is provided by the diagnostics display.
OVLD (OVERLOAD)
WN I
OVLD
The motor is switched on. A motor overload protection warning is pending.
WN O
OVLD
The motor is switched off. A motor overload protection warning is pending.
ER O
OVLD
The motor is switched off. There is a fault at the motor overload protection.
----
OVLD
No motor overload exists.
OVLD% (OVERLOAD in percent)
Functions
8.11 3RW5 HMI Standard
SIRIUS 3RW51 Soft Starter
106
Equipment Manual, 09/2020, A5E37108631002A/RS-AC/003