Modules
4.2 Installing/Removing Line Modules
Blank Modules
RUGGEDCOM RX1500PN PS XXP
Specifications
—
Article Numbers
6GK6015-0AL10-0AA0
(Standard)
6GK6015-0AL10-0AA1
(Conformal Coated)
RUGGEDCOM RX1500PN LM Blank
Specifications
—
Article Numbers
6GK6015-0AL20-0AA0
(Standard)
6GK6015-0AL20-0AA1
(Conformal Coated)
4.2
Installing/Removing Line Modules
Upon installing a new line module in the device, all features associated with the
module are available in RUGGEDCOM RX1510. For more information, refer to the
RUGGEDCOM ROX User Guide
for the RUGGEDCOM RX1510.
Once a line module is removed, all the features associated with the module are hid-
den or disabled in RUGGEDCOM RX1510.
CAUTION
When installing more than one line module in the device, make sure the total power
consumption of all line modules does not exceed 41.5 W (i.e. the total power made
available to the modules by the chassis). If the total power consumption exceeds
this value, power fluctuations and irregular shut downs may occur.
For the maximum power consumption of each line module, refer to
.
NOTICE
Only one WAN line module is supported per chassis.
CAUTION
Contamination hazard – risk of equipment damage
Prevent the ingress of water, dirts and other debris that may lead to premature
equipment failure. Always make sure slots are not left empty and open ports are
protected with plugs or covers.
Removing a Module
To remove a line module, do the following:
1. [Optional] If the device is installed in a rack, remove it from the rack.
RUGGEDCOM RX1510
Installation Manual, 12/2019, C79000-G8976-1055-16
37
