Installing the Device
2
This chapter describes how to install the device, including mounting the device, con-
necting power, and connecting the device to the network.
DANGER
Electrocution hazard – risk of serious personal injury and/or damage to equip-
ment.
Before performing any maintenance tasks, make sure all power to the device has
been disconnected and wait approximately two minutes for any remaining energy
to dissipate.
WARNING
Radiation hazard – risk of serious personal injury.
This product contains a laser system and is classified as a
CLASS 1 LASER PRODUCT
.
Use of controls or adjustments or performance of procedures other than those speci-
fied herein may result in hazardous radiation exposure.
WARNING
Radiation hazard – risk of Radio Frequency (RF) exposure.
This device is compliant with the requirements set forth in FCC 47 CFR, section
1.1307, addressing Radio Frequency (RF) exposure from radio frequency base sta-
tions, as defined in
FCC OET Bulletin 65 [http://transition.fcc.gov/Bureaus/Engi-
neering_Technology/Documents/bulletins/oet65/oet65.pdf]
. The emitted radiation
should be as little as possible. To achieve minimum RF exposure, install the device
when it is configured not to transmit and set it to operational mode remotely, rather
than having a technician enable transmission on-site. For maintenance of the base
station, or other operations which require RF exposure, the exposure should be min-
imized in time and according to the regulations set forth by the country of installa-
tion or the Federal Communications Commission (FCC).
NOTICE
This product contains no user-serviceable parts. Attempted service by unauthorized
personnel shall render all warranties null and void.
Changes or modifications not expressly approved by Siemens AG could invalidate
specifications, test results, and agency approvals, and void the user's authority to
operate the equipment.
RUGGEDCOM RX1510
Installation Manual, 12/2019, C79000-G8976-1055-16
5
