Siemens RUGGEDCOM MX5000RE, Руководство по установке

Страница: 34 / 62

Chapter 2
Installing the Device
RUGGEDCOM MX5000RE
Installation Guide
24 Connecting the Network Cables
and the enclosure's bottom plate when properly tightened. Pay careful attention to avoid damaging the
cables and gaskets.
Section 2.12
Connecting the Network Cables
To connect network cables to the patch panels, do the following for each patch panel:
Connecting Micro-D Cables
1. Connect each cable in the patch panel bundle to the appropriate port. Make sure the cable and port have
identical numbers.
2. Secure the bundled cables to an available cable tie base using one (1) cable tie. Tighten the cable tie until the
bundled cables are held securely.
3. Install additional cable ties where necessary.
Connecting Ethernet Cables
1. Carefully remove the dust caps from one connector at a time.
2. Insert the uncapped connector into the appropriate transceiver on the RUGGEDCOM MX5000. Make sure the
cable and port have the same number, and the transmit and receive fibers are plugged in to the correct side
of the transceiver.
3. Repeat Step 1 and Step 2 for all remaining fiber cables.
4. Secure all fiber cables with the provided Velcro® straps. Wrap the Velcro® cable strap around the fiber cables
tightly, making sure the fiber cables are held securely.
Section 2.13
Installing the Front Panel
To install the front panel for the RUGGEDCOM MX5000RE, do the following:
1. Position the RUGGEDCOM MX5000RE with the front opening facing up.