Siemens FLENDER PLANUREX 2 PBUC Series, Руководство по сборке и эксплуатации

Страница: 49 / 54

49 / 55
BA 9213 en 03/2012
10.4 Lubricants
The quality of the oil used must meet the requirements of the separately enclosed BA 7300 operating
instructions, otherwise the guarantee given by Siemens will lapse. We urgently recommend using one of
the oils listed in BA 7300, because they have been tested and meet the requirements.
To avoid misunderstandings, we should like to point out that this recommendation is in no way
intended as a guarantee of the quality of the lubricant supplied. Each lubricant manufacturer
is responsible for the quality of his own product.
Information on the type, viscosity and quantity of the oil is given on the rating plate on the gear unit and/or
in the supplied documentation.
The quantity of oil indicated on the rating plate is an approximation only. The marks on the dipstick or oil
sight glass are decisive for the amount of oil to be filled in.
The manual containing the current lubricants recommended by Siemens can also be consulted on the
Internet (see back cover).
The oils listed there are subjected to continuous tests. Under certain circumstances the oils recommended
there may therefore later be removed from the range or replaced with further developed oils.
We recommend regularly checking whether the selected lubricating oil is still recommended by Siemens.
If it is not, the brand of oil should be changed.
11. Spare parts, customer­service addresses
11.1 Stocking spare parts
By stocking the most important spare and wearing parts on site you can ensure that the gear unit is ready
for use at any time.
To order spare parts, refer to the spare­parts list.
For further information refer to the spare­parts drawing stated in the spare parts list.
We guarantee only the original spare parts supplied by us.
Please note that spare parts and accessories not supplied by us have not been tested
or approved by us. The installation and/or use of such products may therefore impair
essential characteristics of the gear unit, thereby posing an active or passive risk to
safety. Siemens will assume no liability or guarantee for damage caused by spare
parts and accessories not supplied by Siemens.
Please note that certain components often have special production and supply specifications and that we
supply you with spare parts which comply fully with the current state of technical development as well as
current legislation.
When ordering spare parts, always state the following:
Order number, item Type, size Part number Quantity
11.2 Spare parts and customer­service addresses
When ordering spare parts or requesting a service specialist, please contact Siemens first (see section 2).