Siemens DP/AS-Interface Link 20E, Руководство пользователя

Страница: 76 / 160

Using the Command Interface
76
DP/AS-Interface Link 20E
Release 11/2002
C79000-G8976-C138–04
Table 3-5 Error Coding, continued
DONE Meaning STATUS ERROR
0 1 83A3
H
An AS-i slave with the new address already exists on the
AS-Interface.
0 1 83A4
H
The AS-i slave address cannot be deleted.
0 1 83A5
H
The AS-i slave address cannot be set.
0 1 83A6
H
The AS-i slave address cannot be stored permanently.
0 1 83A7
H
Error reading the extended ID1 code.
0 1 83A8
H
The target address is not plausible (for example a B slave
address was used for a standard slave).
0 1 83B1
H
A length error has occurred transferring a string according
to profile 7.4.
0 1 83B2
H
A protocol error has occurred transferring a string
according to profile 7.4.
0 1 83F8
H
The job number or the job parameter is unknown.
0 1 83F9
H
The AS-i master has detected an EEPROM error.
0 1 8F22
H
Area length area reading a parameter
8F23
H
Area length error writing a parameter
This error code indicates that a parameter is entirely or
partly outside the address area or that the length of a bit
array of an ANY parameter cannot be divided by 8.
0 1 8F24
H
Area error reading a parameter
8F25
H
Area error writing a parameter
This error codes indicates that a parameter is located in an
area that is illegal for a system function.
0 1 8F28
H
Alignment error reading a parameter
8F29
H
Alignment error writing a parameter
This error code indicates that the reference to a parameter
is a bit address other than 0.
0 1 8F30
H
The parameter is in the write-protected global DB
8F31
H
The parameter is in the write-protected instance DB
This error code indicates that a parameter is located in a
write-protected data block.
0 1 8F32
H
The DB number in the parameter is too high
0 1 8F3A
H
The parameter contains the number of a DB that is not
loaded
0 1 8F42
H
An access error has occurred while the system attempted
to read out a parameter from the peripheral area of the
inputs.
0 1 8F43
H
An access error occurred while the system was attempting
to write a parameter to the peripheral area of the outputs