BC8001A Installation and Operating Instruction
Page 34/49
12.4 How to configure point
1~7 steps is the same as “how to configure line”.
8. Press “
↓
” to choose “1.Points” and press “OK” key.
All points are displayed. Press “
↓
” / ”
↑
” to scrow down/up.
9. Press “
↓
” to choose one desired point and press “OK” key.
10. Press “
↓
” to choose “1.Point” and press “OK” key.
The property of the selected point is displayed. The type, text can be modified. Also
different point has different editable item (refer to “Editable Parameter of Different
Points”). Press “
↓
” / ”
↑
” to switch active window.
11. Press “OK” to save the modification and return to the previous window.
Note:
1. Now the modified text is saved temporarily. If the control unit is reset, the modified text
will be lost. If you want to save the modification for long time, please do the “Save
Configuration” operation(refer to Page 44).
2.
Type is a drop-down list. When it is active, press “F” and the drop-down list is displayed.
Press “
↓
” / ”
↑
” to select corresponding type. Press “OK”.
3.
Sensitivity is a drop-down list. When it is active, press “F” and the drop-down list is
displayed. Press “
↓
” / ”
↑
” to select “High”, ”Std” and “Low” according to site situation.
Press “OK”.
4.
AnalogVal: relative value of smoke density.
<Config Line> L 3 A
1. Points
2. Line Property
<Config Point> L 3 A
001 BDS031(A) 001
002 BDS051(A) 002
003 BDS121(A) 003
004 Output Module
<Config Point: 02> L 3 A
Address 02.004.002
Type
Text
Status Trouble
BDS051(A) Smoke
BDS051(A) 002
<Config Point: 02> L 3 A
Mode Normal
Sensitivity
AnalogVal 0
Std
<Config Point> L 3 A
1. Points
2. Logic Statement
