Access to the card slot
The card slot for the memory card is located beneath the black rubber cover fitted at
the side over the corner on the device.
1
2
Figure 8: Slot for microSD memory card (CLV61x-Dxx
X
xx only, where
x
= 3 or 4), illustration may
differ IP65 standard housing
1
Open cover on the device
2
MicroSD memory card
1.
Switch off the supply voltage to the device.
2.
Open the black rubber cover.
To do so, carefully lift the flap of the rubber cover.
3.
Making sure it is in the correct position, insert the memory card into the slot until
it locks into place. When doing this, position the contacts so that they are facing to
the rear and upwards, see the card symbol on the device.
4.
Close the rubber cover. Make sure that the cover is completely flush with the
housing.
5.
Switch on the supply voltage for the device.
Interpretation of the card content
Once it is switched on, the device automatically detects the presence of a memory card.
Depending on the content of the card, the device behaves as follows:
■
If the card is empty or contains a parameter set that cannot be interpreted, the
device saves its currently valid internal parameter set to the memory card. The
prerequisite is adequate storage space on the card. The device then starts with
the internal parameter set.
■
If the card contains a parameter set that can be interpreted, the device perma‐
nently overwrites its previously valid internal parameter set with this parameter
set. The device then starts with the now valid parameter set.
■
The goal is for the internal parameter set and the parameter set saved externally
to always be identical.
When using PROFINET, the device adopts the highest ranking parameter set in the
following hierarchical sequence:
PRODUCT DESCRIPTION
3
8017842/19XD/2021-11-19 | SICK
O P E R A T I N G I N S T R U C T I O N S | CLV61x DualPort (PROFINET)
25
Subject to change without notice
