Operating Instructions
Chapter
10
CLV 480 Bar Code Scanner
8 010 080/O824/10-02-2005
©
SICK AG · Division Auto Ident · Germany · All rights reserved
10-29
Appendix
10.6
Installing and operating the "CLV-Setup" program
The scope of delivery of the CLV includes a CD-ROM ("Manuals & Software") containing the
"CLV-Setup" program. The software can be installed on a PC with the following minimum
configuration: 80486 processor, 66 MHz, and 16 MB RAM, CD drive, serial interface and
mouse (recommended) as well as an operating system Windows 95
TM
/98
TM
, Windows NT
TM
,
Windows 2000
TM
or Windows XP
TM
.
Approximately 25 MB of hard disk space is required to install CLV-Setup (V 4.10) and CLV
Assistant, approximately 20 MB to install CLV-Setup Help (V 4.10).
Note
For the lastest version of the software, see
www.sick.com
.
10.6.1
Preparations
1.
Make sure you have the CD-ROM ("Manuals & Software") at hand.
2.
Connect the CLV to the AMV/S 60 Connection Module (see
3.
Connect the PC to the terminal interface on the CLV using a 3-core RS 232 data cable
(null modem cable) (AMV/S 60: connect the PC to the internal 9-pin "Service" plug).
Chapter 5.5.5 Connecting the CAN interface, Page 5-16
4.
Switch on the power supply to the AMV/S 60.
Once the CLV has started, the "Device Ready" LED lights up.
5.
Switch on the PC and start Windows.
10.6.2
Installing the software
The "CLV-Setup" installation program creates a directory "CLV", a series of subdirectories,
and the necessary links. A deinstaller is also installed automatically so that you can remove
the program from the PC at any time. As of version V 2.6, CLV-Setup will only be available
and further developed as a 32-bit application.
Note
The following instructions describe how to install the software on Windows XP
TM
. These in-
structions may differ depending on the operating system you are using (for example, admin-
istrator rights are required to install the software on Windows XP
TM
).
Initial installation
User software CLV-Setup:
1.
Shut down all the applications running in Windows.
2.
Insert the CD-ROM into the CD-ROM drive.
3.
If the auto run function is enabled, the start page (table of contents) of the CD-ROM is
automatically displayed in the your browser.
4.
Select the S
OFTWARE
folder on top left.
5.
Select CLV, ICR, OPS S
ETUP
S
OFTWARE
in the listing.
A table with CLV-Setup information is displayed.
6.
Select D
OWNLOAD
under S
OFTWARE
FILE
.