3 D D R I V E R A S S I S TA N C E S Y S T E M | 3 V I S T O R - P
8018167 / 2015-03-31 | S I C K A G
Subject to change without notice
6 9
CONFIGURATION AND OPERATION
r
Activates/deactivates the image capture function.
The selected status is indicated in the system information.
s
Toggles between the various display modes for both cameras when-
ever it is pressed.
1. Operator view (right camera).
2. Installer view with degraded performance without fisheye (right
camera).
3. Installer view (left camera).
4. Installer view with degraded performance without fisheye effect
(left camera).
The F1 – F3 functions have to be used when the image from the right-hand camera is
active ("s" button).
F1
Shows/hides the vehicle symbol and the alarm zones in the top right-
hand corner of the display
F2
Shows/hides the contours of the ground.
F3
Shows/hides the detected object rectangles.
F6
Activates/deactivates the acoustic warning signals.
F12
Activates/deactivates the inclusion of the image capture symbol on
the display.
q
Resets all the settings for setup mode and restarts the software.
8.3
Operating the 3vistor-P
Operating the driver assistance system is simply a question of switching it on via the
vehicle ignition key and then paying attention to any optical and acoustic alarm signals
output via the display.
NOTE!
If an alarm is signaled, stop the vehicle immediately and wait until the object is com-
pletely clear of the alarm zone.
The alarm indicator lights up as follows:
•
Gray
when an object is present in defined alarm area 1.
•
Red
when an object is present in defined alarm area 2.
•
No alarm indicator
when no object is present in the defined alarm area.
The indication of this information does not release the driver from his/her respon-
sibility to drive carefully and prudently.
