3 D D R I V E R A S S I S TA N C E S Y S T E M | 3 V I S T O R - P
8018167 / 2015-03-31 | S I C K A G
Subject to change without notice
6 8
CONFIGURATION AND OPERATION
7. Check whether an alarm is triggered when the alarm area is violated
(area 1 = gray, area 2 = red).
Detected objects are shown as blue dots within the alarm zone displayed.
NOTE!
If any of these checks fail to produce the desired results, you must repeat the configura
-
tion process for the parameter concerned.
8. On completion of the checking process, remove the USB dongle and put the cover
back over the USB connection.
NOTE!
During normal operation, the driver assistance system must not be operated with USB
devices still connected.
8.2
Setup mode
To activate setup mode, press the relevant shortcut key while in "Operator mode ". This
mode enables you to check a completed configuration and to make further settings for
"Operator mode".
Shortcut
Description
i
Shows/hides system information.
d
Shows/hides the 3D point cloud calculated for the current scene.
g
Uses a software or hardware value to bypass the signal of the select-
ed gear (discrete "gear"). Make sure no gear is selected when using
this function. To change the settings, you must press the button
again.
1. Reverse gear simulated
2. Forward gear simulated
3. Gear controlles by hardware
The selected mode is always indicated in the system information
(shortcut "i").
