18 User manual GC600-GC600
Mains
Esc/SHIFT
button pressed, you stop the rotation.
If there are no configured inputs on a
page, the page is not displayed.
On each line the controller shows the configured text for the digital input and the logic status of the
input.
The page
S.11 (DIGITAL INPUTS)
displays the status of:
Digital inputs
Analogue inputs used as digital (if they are not used as digital they are displayed with
hyphens).
Virtual digital inputs
The page
S.12 (DIGITAL INPUTS)
is displayed only if
DITEL
modules have been configured. It displays
the status of the digital inputs acquired by
DITEL
modules. If a
DITEL
module does not
communicate correctly, the controller displays some hyphens in place of the input
’s status.
Page
S.13 (DIGITAL OUTPUTS)
shows the status of controller digital outputs.
Page
S.14 (DIGITAL OUTPUTS)
is displayed only if
DITEL
modules have been configures. It displays
the status of the digital outputs controlled by
DITEL
modules. If a
DITEL
module does not
communicate correctly, the controller displays some hyphens in place of the
input’s status.
ACK/ENTER
button scrolls through three different pages
(LOGIC STATE, PHYSICAL STATE,
BY FUNCTION),
showing the status of the digital inputs or outputs:
•
LOGIC STATE
: The inputs/output logic state (active or inactive) used by the controller in the
management of the operating sequence.
•
PHYSICAL STATE
: Electrical level (active or inactive, or high or low) really present on the
input/output; this can be the opposite in comparison to the corresponding logic state.
Displayed in negative.
•
BY FUNCTION
(only for pages
S.11
and
S.13
: the controller shows a list of functions really
associated to the digital inputs/outputs, displaying the logic status (1/0) related to each
function, independently from the input/output really associated to the functions. If more than
8 inputs/outputs are configured on each page, the controller shows them all letting them
rotate (8 at a time) every two seconds: keeping the
Esc/SHIFT
button pressed, you
stop the rotation.
Page
S.15 (ANALOG INPUTS)
displays the value of the Gen-set control module's analogue inputs.
Pressing
ACK/ENTER
it is possible to display the rotating inputs in two different ways:
•
PHYSICAL STATE
: For each input the measure in Volt is displayed, for terminals JK-2, JK-
3, JK-4 and JK-5 the measure in Ohm is also displayed.
•
BY FUNCTION:
the controller shows a list of the functions really associated to the analogue
inputs, showing the relative acquired value, independently from the input really associated
to the functions. If more than 8 inputs/outputs are configured on each page, the controller
shows them all letting them rotate (8 at a time) every two seconds: keeping the
Esc/SHIFT
button pressed, you stop the rotation.
