14 User manual GC600-GC600
Mains
The variation of the parameters requires the “
OFF/RESET”
operating mode.
Some parameters can also be modified with operating modes different than “
OFF/RESET”
.
If it is not permitted to change a value in any condition, it will be represented in the following manner:
<400> showing that the parameter cannot be changed in this status.
To exit the programming menu, use the
Esc/SHIFT
button.
Some parameters require the setting or modification of the alphanumeric strings.
In this case, pressing
ACK/ENTER
makes the square brackets [...] around the variable flash,
and a cursor appears under the first character of the string.
Using the
LEFT
and
RIGHT
buttons, you can select which character to change. Then,
use the
UP
Ref. 1a
and
DOWN
Ref. 1a
buttons to change the character selected. Repeat
the procedure for each character that needs changing.
Use
ACK/ENTER
(confirm) or
Esc/SHIFT
(abort) to end the procedure.
You can open the last programming page displayed directly. This is possible if, when exiting
programming mode, instead of going back though the menus until you exit programming, you hold down
Esc/SHIFT
for approximately 2 seconds.
The same is true when accessing the programming mode after Gen-set has automatically exited
programming. This occurs if, for 60 consecutive seconds, no operations are performed on the
programming or if the operating mode is c
hanged to “
MAN”
or “
AUTO”.
Protections and alarms can generally be configured using dedicated variables. Generally, the trip time
can also be configured.
INFORMATION! Setting the trip time to 0 disables the protection.
The status pages from
L.01
to
L.07
contain the information related to the PLC logic and they are
displayed only if the controller is equipped with a valid PLC program. Refer to technical manual for
information on PLC.
Page
L.01 (PLC)
contains identification information of the PLC program installed in the PC, as:
•
The title and the description of PLC program.
•
The date of the last modification.
•
The firmware PLC version of the filler and the editor.
