SHOWTEC 30751, Руководство пользователя

Страница: 13 / 24

12
Ordercode: 30751
Sunstrip Active MKII 110V
Control Panel
A) LED display
B) Mode button
C) Menu button
D) Up button
E) Down button
Fig. 04
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address, next time.)
DMX Addressing
The control panel on the back side of the device allows you to assign DMX fixture addresses, which is the
first channel with which the Sunstrip will respond to the controller.
Please note, when you use the controller, the unit has 10 channels.
When using multiple Sunstrips, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Sunstrip should be 1(A001); the DMX address of the second Sunstrip
should be 1+10=11 (A011); the DMX address of the third Sunstrip should be 11+10=21 (A021), etc. Please,
be sure that you do not have any overlapping channels in order to control each Sunstrip correctly. If two
or more Sunstrips are addressed similarly, they will work similarly.
Controlling:
After having addressed all Sunstrips, you may now start operating these via your lighting controller.
Note: After switching on, the Sunstrip will automatically detect whether DMX 512 data is received or not.
If there is no data received at the DMX-input, the “LED“ on the control panel will not flash.
If not, the problem may be:
●
The XLR cable from the controller is not connected with the input of the Sunstrip.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 10 seconds
When no button is pressed for 10 seconds, the display will turn off.
To light up the display, you have to press the Mode, Menu, Up or Down button.
Once you have pressed the button, the display will light up.