3
Ordercode: 30751
Sunstrip Active MKII 110V
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
●
Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
●
Never modify, bend, mechanically strain, put pressure on, pull or heat up the power cord.
●
Never strain the cable insert or the female part in the device. There must always be sufficient cable
going to the device. Otherwise, the cable will be damaged, which can cause serious damage.
●
Never remove warning or informative labels from the unit.
●
Never use anything to cover the ground contact.
●
Never lift the device holding it by the projector-head, as the mechanics may be damaged. Always
hold the device by the transport handles.
●
Never place any material over the lens.
●
Never look directly into the light source.
●
Never use the device without the lamp.
●
Never ignite the lamp if the objective lens or any housing cover is open, as discharge lamps may
expose and emit a high ultraviolet radiation, which may cause burns.
●
In case of strobe fixtures: Never operate the stroboscope without protective shield! When the shield is
cracked, replace it before using the device again.
●
Never leave any cables lying around.
●
Never use the device during thunderstorms, unplug the device immediately.
●
Never leave various parts of the packaging (plastic bags, polystyrene foam, nails, etc.) within
children’s reach, as they are potential sources of danger.
●
Do not insert objects into air vents.
●
Do not open the device and do not modify the device.
●
Do not switch the device on and off in short intervals, as this will reduce the device’s life.
●
Do not touch the device’s housing bare-handed during its operation (housing becomes very hot).
Allow the device to cool for at least 5 minutes before handling.
●
Do not shake the device. Avoid brute force when installing or operating the device.
●
Do not install lamps of higher wattage.
●
Only use the appropriate lamp for your unit. Note that product versions, that use other lamps, may
be offered in the future. Check your product specification label for information.
●
Only use the device indoors, avoid contact with water or other liquids (only applies to devices with
IP<=65).
●
Only operate the device after having checked if the housing is firmly closed and all screws are tightly
fastened.
●
Only operate the device after having familiarized with its functions.
●
Avoid flames and do not put close to flammable liquids or gases.
●
Always replace the lamp, when it is damaged or deformed due to the heat.
●
Always keep the case closed while operating.
●
Always allow a free air space of at least 50 cm around the unit for ventilation.
●
Always disconnect power from the mains, when device is not used, before cleaning or when
replacing lamp! Only handle the power cord holding it by the plug. Never pull out the plug by
tugging the power cord.
●
Make sure that the device is not exposed to extreme heat, moisture or dust.
●
Make sure that the available voltage is not higher than stated on the rear panel.
●
Make sure that the power cord is never crimped or damaged. Check the device and the power
cord from time to time.
●
Make sure that the core diameter of extension cords and power cords is sufficient for the required
power consumption of the device.
●
If the lens is obviously damaged, it has to be replaced to prevent its functions from being impaired,
due to cracks or deep scratches.
●
If the external cable is damaged, it has to be replaced by a qualified technician.
●
If device was dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
●
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
Содержание 30751
Страница 22: ...21 Ordercode 30751 Sunstrip Active MKII 110V Dimensions Leftside Rightside...
Страница 23: ...22 Ordercode 30751 Sunstrip Active MKII 110V Notes...
Страница 24: ...2020 Showtec...
