SHOWTEC 30751, Руководство пользователя

Страница: 11 / 24

10
Ordercode: 30751
Sunstrip Active MKII 110V
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 2 modes: ● Chase mode
● DMX-512 (1CH, 2CH, 5CH or 10CH)
One Sunstrip Active (Chase mode)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Sunstrip Active is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 13 for more information about the Chase mode.
Multiple Sunstrips Active (DMX Control)
01)
Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Sunstrips Active and other devices.
04)
Link the units as shown in Fig. 09. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second and third units.
05) Supply electric power: Plug electric mains power cords into each unit's Neutrik Powercon, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.