Shop fox W1845, Руководство пользователя

Страница: 22 / 48

-20-
Model W1845 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Sanding.Spindle
The Model W1845 comes with a spindle sanding
attachment for sanding curved surfaces. The included
sanding drums measure 1
1
/
2
", 2", and 3" in diameter. Be
sure to periodically adjust table height to minimize spot
wear on the spindle/belt.
Items.Needed:. Qty
Sanding Drum (dia. of choice) ................................1
Table Insert (dia. of choice) ..................................1
To install sanding spindle, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Release the belt guard latch, open cover, and latch
cover to the belt access door.
3..
Remove the (3) cap screws and false cover from the
drum.
4.. Line up the screw holes and place the spindle into
the drum.
5. Thread cap screws removed in Step 3 into drum and
tighten, as shown in Figure 12.
6. Slide sanding drum onto spindle, and insert spindle
washer and hex bolt into top of spindle.
7. Insert rod into hole in base of spindle to anchor it,
and tighten hex bolt, as shown in
Figure 13.
8. Insert spindle table assembly shaft into opening in
idler roller bracket (see
Figure 14).
9. Thread table lock handle into pre-tapped hole in
idler roller bracket.
Note: The handle is spring-loaded and can be used
as a ratchet.
10.
Remove 4" table insert by removing (3) flat head
screws in the insert.
11. Replace with table insert that matches sanding drum
diameter. Tighten with flat head screws removed in
Step 10.
Figure 13 . Using included rod to anchor
spindle.
Figure.14..
Spindle table assembly
installed.
Idler
Roller
Bracket
Spindle
Table
Assembly
Figure 12 . Tightening spindle cap screws.
Rod