Shop fox W1845, Руководство пользователя

Страница: 34 / 48

-32-
Model W1845 (For Machines Mfd. Since 6/17)
SE
RV
IC
E
SERVICE
General
MAKE. SURE. that. your. machine. is.
unplugged. during. all. service. proce-
dures!. If. this. warning. is. ignored,. seri-
ous.personal.injury.may.occur.
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
techsupport@woodstockint.com.
Calibrating.Angle.Gauge
In order to maintain accuracy and precision with the
oscillating edge sander, periodically calibrate the angle
gauge.
Tools.Needed. Qty
Machinist's Square ..............................................1
Flat Head Screwdriver .........................................1
To.calibrate.the.angle.gauge,.do.the.following.steps:
1.
DISCONNECT MACHINE FROM POWER!
2. Loosen angle adjustment lock handle (see
Figure 32 ).
3. Place machinist's square on table and press it against
the platen, as shown in
Figure 33
.
4.
Adjust platen until it is flush with the machinist's
square.
5. Tighten angle adjustment lock handle.
6. Loosen angle indicator pin screw, shown in
Figure.32
,
1
⁄
2
turn.
7.
Align angle indicator pin with the 90˚ mark and
tighten angle indicator pin screw.
Figure 33 . Aligning table to platen.
Machinist's
Square
Figure.32.
Angle indicator pin screw.
Angle Indicator
Pin Screw
Angle Adjustment
Lock Handle