Shop fox W1845, Руководство пользователя

Страница: 19 / 48

-17-
Model W1845 (For Machines Mfd. Since 6/17)
SE
TU
P
Assembly
Before beginning the assembly process, refer to
Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run
.
To.assemble.machine,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Open belt access door by removing star knobs (see
Figure 5 ) and opening all latches.
3.
Lift belt tensioning lever, as shown in
Figure.6
.
4.
Determine belt direction from arrows on dust port
and access door.
5. Match arrows on sander to arrows inside sanding
belt. Place and center belt on sanding drums.
6..
Tension sanding belt by pushing belt tensioning lever
down.
7. Close belt access door, insert star knobs, and latch
levers.
8..
Adjust belt tracking as described on
.Page.21
.
DO. NOT. attempt. to. perform. any.
adjustments. to. the. sanding. belt. while.
the. machine. is. connected. to. a. power.
source.. Failure. to. unplug. before.
adjusting.the.sanding.belt.could.result.
in.serious.personal.injury.
Figure 6
. Belt tensioning lever in released
position.
Figure.5.
Star knobs securing belt access
door.
Star Knobs