Shop fox W1845, Руководство пользователя

Страница: 32 / 48

-30-
Model W1845 (For Machines Mfd. Since 6/17)
SE
RV
IC
E
Lubrication
After operating the Model W1845 for approximately 500
hours, check the gearbox oil level and refill as needed.
Items.Needed:. Qty
Open-End Wrench 10 x 12mm ................................1
Hex Wrench 5mm ...............................................1
Grease Gun w/All-Purpose Grease ...........................1
Oil Can w/Light Machine Oil ..................................1
SAE 80W Gear Oil ................................... As Needed
Rack.and.Pinion.Gear
The rack and pinion gear that moves the table vertically
should be greased well to maintain smooth operation.
To.grease.rack.and.pinion.gear,.do.these.steps:
1..
With table in its lowest position, wipe rack and
pinion with a rag to remove buildup of sawdust and
old grease.
2.
Apply a coat of all-purpose grease to rack and pinion
gears.
Note: All other bearings on Model W1845 are sealed
and permanently lubricated.
Oil.Ports.&.Grease.Fittings
There are two oil ports shown in
Figure.28.
and four
grease fittings shown in Figure.29. Lubricate these points
after approximately 50 hours of use.
Figure.26.. Gearbox cap screws.
Figure.29. Grease fittings inside sanding
body.
Figure.28. Oil ports on oscillating
assembly.
Figure.27.
Oil fill hole and fill plug.
Checking/Refilling.Gearbox.Oil
1.. DISCONNECT MACHINE FROM POWER!
2. Place belt sander in horizontal position.
3. Remove cap screws on top of gearbox cover shown in
Figure.26
.
4.
Remove hex bolts on opposite side of gearbox and
remove the gearbox cover.
5. Remove oil fill plug on top of gearbox, as shown in
Figure.27
,
and fill with SAE 80W gear oil until level
is
1
/
2
" from top. Replace oil fill plug.
6. Re-install gearbox cover with hex bolts and cap
screws removed in
Steps 3-4.