SHNING 3D Aoralscan 2, Руководство пользователя

Страница: 26 / 112

Aoralscan 2 User Manual
SHNING 3D TECH Co.,Ltd Copyright

2019 All Rights Reserved
- 25 -
NOTES

When the scanner is left idle for 10 minutes (including being placed on
a desk), it will go into standby mode. After 1 minute of inactivity, it will
automatically go into sleep mode, and the LED ring light on the end of the
scanner body will also go off.

To activate the scanner, place it in the cradle. The scanner will go into
standby mode within 3 minutes. If the scanner is left idle for more than 1
minute, it will automatically go into sleep mode.

To lower the temperature inside scanner body, the cooling fan still
operates for about 30 minutes after the scanner goes into standby or sleep
mode. Then it will stop spinning.

The scanner tip is being heated whenever power is supplied, even if
the scanner is in standby or sleep mode.
USB cable storage
To prevent the USB cable from getting damaged by excessive bending or
twisting, you should loosely coil the cable and avoid making kinks or sharp
bends.
CAUTION
Do NOT roll the cable over the handle of the scanner or even bend
the cable sharply. The illustration below demonstrates improper cable
storage