SHNING 3D Aoralscan 2, Руководство пользователя

Страница: 24 / 112

Aoralscan 2 User Manual
SHNING 3D TECH Co.,Ltd Copyright

2019 All Rights Reserved
- 23 -
3.3. Scanner Overview
3.3.1. Tip and scanner body
No. Component Function
1.
Scanner tip
Use the tip to scan the upper jaw, lower jaw, or total jaw.
The tip(s) can be autoclaved up to 20 times.
2.
Heater
The anti-condensation heater prevents fogging on the
mirror to ensure successful scanning.
3.
Exhaust vents
Allows the heat produced by the operation of scanner to
be dissipated from the case.
4. Intake vent
Allows the ambient cool air to enter into the case to help
cool down the heat produced by the operation of scanner.
NOTE
When scanning, do not hold the scanner in the way that
covers or blocks the intake and exhaust vents.
Otherwise the scanner may become overheated.
5. LED ring light
Indicates the status of your scanner.

Blinking green: the scanner is in
preparation/warm-up mode.

Solid green: the scanner is ready for use.

Solid blue: the scanner is processing the alignment of
scanned data.

Solid amber: an error occurs and needs your attention.
Table 3-1 Introduction to the scanner tip and scanner body