32
5.3 Setting the Ribbon Cassette
(1) Press the “REC” key for 3 seconds or longer.
Recording stops. With the power turned on, press the “REC” key for 3 seconds or longer.
Once recording stops, the REC indicator goes off. (See Fig. 5.1-1 on page 23.)
The pen and printer automatically move, discontinuing paper feed. No. 1 pen (red) records the
left side (approx. 15 %) and No. 2 pen (green) records the right side (approx. 85 %),
respectively. (See Fig. 5.1-2 on page 23.)
(2) Open the Door.
Push the door hook to unlock the door. Pull the door to open it. (See Fig.5.1-3 on Page 24.)
(3) Move the Pen up.
Push the pen-up lever upward to move pen tips away from the chart paper. (Move the pen up;
See Fig.5.1-4 on page 24)
(4) Pull out the Chart Holder.
Put your fingers onto the levers at both sides of the chart holder and pull it out. (See Fig.5.1-5
on page 25.) The guide shaft, printer, and the main shaft are laid out as shown in the figure
below. (The main shaft is invisible if the ribbon cassette has been set.)
Fig. 5.3-1 Layout of Guide Shaft, Printer and Main Shaft
CAUTION
If recording operation is activated while the chart holder is removed, the ink ribbon may be
damaged. To replace the ribbon cassette, be sure to press the “REC” key to stop recording.
Be sure to move the cartridge pen up. Otherwise, it will be damaged.
Main Shaft
Printer
Guide Shaft
CAUTION
Maximum angle of the fully opened door is 135 degrees. Do not open the door any further, as the
hinge will break.
WARNING
To avoid injury to fingers, be careful when opening/closing the door.
Содержание HR-700
Страница 1: ...HYBRID RECORDER HR 700 PEN WRITING INSTRUCTION MANUAL ...
Страница 122: ...121 ...
Страница 123: ...122 ...