Shindaiwa DGM60MK, Руководство пользователя

Страница: 38 / 48

35
5
(5) Fuel Filter Replacement (Main and Pre-Filters)
Replace Every 400 hours
Remove the fuel filter using a filter wrench.
Spread a thin layer of oil on a new fuel filter gasket.
Thread the fuel filter by hand, and turn by hand (do not use a
filter wrench) from when the gasket contacts the seal surface
until it is securely tightened.
Shortly after starting the engine, always be sure to check
that there is no fuel leaking from the seal surface.
< NOTE >
Be sure to wipe away any fuel that has spilled out of the piping when removing the filter.
Fuel filter part nos.: Main filter 1G390-43171 (Kubota part no.)
Pre-filter 16631-43562 (Kubota part no.)
(6) Draining Water from the Fuel Tank
Drain Water Every 200 hours
Remove the fuel drain plug and packing (with rubber seal).
After the water has been drained, reinsert the fuel drain plug
with new packing (with rubber seal).
< NOTE >
Replace the packing of the fuel drain plug with new packing each
time the water is drained.
Packing part no.: V106-000110
After reinserting the fuel drain plug, be sure to always check that there is no fuel leakage.
(7) Coolant Replacement
Replace Every 1000 hours
Remove the radiator plate.
Remove the radiator cap.
Remove the coolant drain plug and packing.
After the coolant has been drained, reinsert the coolant
drain plug with new packing.
Remove the subtank and flush the coolant from the
subtank.
Reattach the subtank to its original position and fill with
coolant until it reaches the FULL level.
Fill the radiator with coolant until it reaches the filler
neck.
Re-attach and tighten the radiator cap.
Attach the radiator plate.
< NOTE >
Refer to section “8-2. Checking Coolant” for coolant
information.
1
1
6
7
8
1
FULL
Sub-tank
LOW
Water Drain
Plug
2
Gasket
3
4
2
Fuel Drain Plug
Filler Neck
Radiator Cap
Radiator Plate
2
3
4
9