Shindaiwa DGM60MK, Руководство пользователя

Страница: 42 / 48

39
(10) Oil Separator Filter Replacement
Replace Every 1000 hours
Remove the cover, and remove the O-ring and oil separator filter.
Assemble a new O-ring to the cover and spread a thin layer of oil on the O-ring.
Assemble a new oil separator filter and tighten the cover by hand.
< NOTE >
Replace with a new O-ring each time the oil separator filter
is replaced.
Oil separator filter part no. (with O-ring)
1J419-05811 (Kubota part no.)
11. Long-Term Storage
WARNING : INJURY
Always be sure to stop the engine and remove the engine key when
performing inspection or maintenance.
CAUTION : FIRE
Always be sure to wipe up any spilled fuel or oil.
Allow the generator to cool before covering with the protective cover.
CAUTION : BURNS
Do not touch the engine and surrounding components immediately after
stopping the engine as they are still hot.
(1) Storage Procedures
Perform the following maintenance procedures before storing this generator if it is not going
to be used for two months or more.
Remove the battery.
(Refer to section “8-7. Checking the Battery Replacing the Battery”.)
Replace the engine oil.
(Refer to section “10. Inspection/Maintenance (1) Engine Oil Replacement”.)
Drain the fuel from the fuel tank and filter.
(Refer to section “10. Inspection/Maintenance (5) Fuel Filter Replacement (Main
and Pre-Filters)”.)
(Refer to section “10. Inspection/Maintenance (6) Draining Water from the Fuel
Tank”.)
1
2
Oil Separator
Oil Separator
Oil Separator
Cover
O-ring
Loosen Tighten
Filter
2
1
3
3