Shimadzu AP W Series, Инструкция по эксплуатации

Страница: 22 / 169

22
1 1
Setup Setup
Attaching the Parts (Semi-Micro Models)
1.
Attach the shield case
Align the center hole on the shield case with the
protrusion positioned at the pan’s center axis, and set
it carefully in place.
2.
Put the pan supporter in place
Use the notches (two places) to carefully set the pan
supporter in place on the axis so that it is centered in
the weighing chamber.
CAUTION
There is a risk of damage when placing the pan supporter, so make
sure to hold it by the depressions and place it gently.
3.
Put the pan on the pan supporters
Align the pan grooves (2 grooves) with the left and right
positions of the balance main body.
4.
Attach the stage
Position the stage so the skirt is against the back, and
open both pan doors. Then, tilt the front of the stage
upward at an angle and bring it down slowly to attach.
5.
Attach the multi-stand when necessary
When using medical packaging paper that is bigger than
the pan’s diameter, when putting a package or a container
such as a micro-tube on the pan, or when weighing a long,
cylindrical sample, replace the pan with the multi-stand
or with the special pan used for fixing the multi-stand. To
remove the pan, press down on one side of the pan to lift
up the pan. Then, grab the opposite side to remove.
[How to remove pan]
Press down to lift up the pan Grab the opposite side that
lifts up and remove
Shield case
(Step 1)
Protrusion
around pan’s
axis (Step 1)
OK
FUNC
g
d
pan (Step 3)
pan supporter
(Step 2)
OK
FUNC
g
d
OK
FUNC
g
d
Center protrusion
Outer protrusion
Pan for fixing the multi-stand