Sharp AL-1661CS, Руководство по обслуживанию

Страница: 82 / 216

AL-1661CS TEST COMMAND, FAX SOFT SWITCH, TROUBLE CODES 10 - 6
6 01 Paper feed solenoid
(CPFS1, CPFS2, MPFS)
operation check (PSOL
CHK) [Function]
When [ENTER/START] key is pressed, the selected paper feed solenoid repeats ON for 500ms and
OF for 500ms 20times.
When [
←
/
→
/10KEY] is pressed, the paper feed solenoid setting is switched.
[Operation]
02 Resist roller solenoid (RRS)
operation check (RES.R
SOL CHK) [Function]
When [ENTER/START] key is pressed, the resist solenoid repeats ON for 500ms and OFF for 500ms
20 times.
[Operation]
7 01 Check of warm-up display
and aging with JAM (W-UP/
AGING) [Function]
Copying is repeated to make the set quantity of copies.
When the test command is executed, warm-up is started and warm-up time is added for every second
from 0 and displayed.
When warm-up is completed, addition is stopped. When [CA] key is pressed, the ready lamp lights up.
After that, enter the copy quantity with [10KEY] and press [ENTER/START] key to repeat copying of
the set quantity (interval 0sec).
To cancel the test command, turn off the power or execute a test command which causes hardware
reset.
[Operation]
06 Interval aging (INTERVAL
AGING) [Function]
Copying is repeated to make the set quantity of copies.
When the test command is executed, warm-up is performed and the ready lamp is lighted.
Enter the copy quantity with the [10KEY] and press [ENTER/START] key, and copying is executed to
make the set quantity of copies, and the ready state is kept for 3sec, and copying is executed again to
make the set quantity of copies. These operations are repeated.
To cancel the test command, turn off the power or execute a test command which executes hardware
reset.
[Operation]
08 Shift to copy with warm-up
display (Shift to equivalent to
CA key) (W-UP C-MODE) [Function]
Enter the test command code, and warm-up is started and warm-up time is counted for every second
from 0 and displayed.
When [CA] key is pressed during counting up, "0" is displayed on the display and counting is stopped.
However, warm-up is continued.
After completion of warm-up, counting is terminated. (The aging function is removed from test com-
mand 7-01.)
[Operation]
Main
code Sub
code
Contents Details of function/operation
Code number Setting Remark
0 CPFS1
1 CPFS2 Operation is possible only when No. 2 cassette is installed.
2 MPFS
1) Initial display
2)
[→
/10KEY]
2) [
←
/10KEY]
3) [ENTER/START]
4) Returns to the initial display.
06-01 PSOL CHK
0:CPFS1
06-01 PSOL CHK
1:CPFS2
06-01 PSOL CHK
2:MPFS
06-01 PSOL CHK
EXECUTING...
1) Initial display
06-02 RES.R SOL CHK
EXECUTING...
1) Initial display 2) After 10sec
07-01 W-UP/AGING
0
07-01 W-UP/AGING
10
1) Initial display (Basic display of copy)
READY TO COPY
100% A4 0
1) Initial display 2) After 10sec
07-08 W-UP C-MODE
0
07-08 W-UP C-MODE
10