SEW-Eurodrive M1 N Series, Руководство по сборке и эксплуатации

Страница: 41 / 112

5
Installation/assembly
Prerequisites for installation
Assembly and Operating Instructions – M1..N Series Single-Stage Helical Gear Units
41
5.4 Prerequisites for installation
Check that the following conditions have been met:
• The information on the motor's nameplate must match the voltage supply system.
• The drive has not been damaged during transportation or storage.
• The ambient temperature matches the information in the order documents.
• No harmful oils, acids, gases, vapors, radiation etc. in the vicinity.
NOTICE
Danger due to insufficiently cleaned flange surfaces.
Possible damage to property.
• Clean the output shafts and flange surfaces thoroughly to ensure they are free of
anti-corrosion agents, contamination or similar. Use a standard solvent. Do not
let the solvent come into contact with the sealing lips of the oil seals.
5.4.1 Extended storage
Observe the following: The service life of the lubricant in the bearings is reduced if the
unit is stored for ≥ 1 year (applies only to bearings with grease lubrication).
Replace the screw plug with the breather.
29203856/EN – 03/2020