SEW-Eurodrive M1 N Series, Руководство по сборке и эксплуатации

Страница: 10 / 112

2
Safety notes
Designated use
Assembly and Operating Instructions – M1..N Series Single-Stage Helical Gear Units
10
Specialist for elec-
trotechnical work Any electrotechnical work may be performed only by electrically skilled persons with a
suitable education. Electrically skilled persons in the context of this documentation are
persons who are familiar with electrical installation, startup, troubleshooting, and main-
tenance of the product who possess the following qualifications:
• Qualification in the electrotechnical area in accordance with the national regula-
tions
• Familiarity with this documentation
Additional qualifi-
cation In addition to that, these persons must be familiar with the valid safety regulations and
laws, as well as with the requirements of the standards, directives, and laws specified
in this documentation.
The persons must have the express authorization of the company to operate, pro-
gram, parameterize, label, and ground devices, systems, and circuits in accordance
with the standards of safety technology.
Instructed persons All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately. The purpose of the instruction is
to give persons the ability to perform the required tasks and work steps in a safe and
correct manner.
2.4 Designated use
The industrial gear units are gear units run by motors for industrial and commercial
systems. The units may only be run at the speeds and powers shown in the technical
data or on the nameplate. Implementing gear unit loads other than the permitted val-
ues or operating the gear units in areas of application other than industrial and com-
mercial systems is only permitted after consultation with SEW‑EURODRIVE.
Using these products in potentially explosive atmospheres is prohibited, unless spe-
cifically designated otherwise.
In compliance with the EC Machinery Directive 2006/42/EC, the industrial gear units
are components for installation in machinery and systems. In the scope of the EC di-
rective, you must not take the machinery into operation in the designated fashion until
you have established that the end product complies with Machinery Directive 2006/42/
EC.
2.5 Other applicable documentation
Also observe the following publications and documents:
• M1..N Series catalog
• Order documents, such as dimension sheet, order confirmation, etc.
• If required, the "AC Motors" operating instructions
• If required, the operating instructions of the options installed
29203856/EN – 03/2020