SentexSystems CROWN JEWEL, Руководство по программированию расширенных функций

Страница: 31 / 39

Rev B Doc. 6001141 Page 25 of 33
B. RESTORING FACTORY SETTINGS (STEP 31)
To restore factory settings for programming steps 1, 6, 7, 8, 9, 10, 12, 13, 20, 21, 23, 24, 26, 29, 36,
and 40.
Format 31 + “#”
•
The factory settings are listed on the chart located below.
NOTE When you initiate this step, the doors/relays that were latched (timed or untimed) before
this step, will become unlatched. It is necessary for you to program the unit to latch
these relays again using steps 91 through 99.
STEP PURPOSE FACTORY SETTING
01 Changing the Programming Access Code 000000
06 Setting the Visitor Double Ring Enabled
07 Setting the Maximum Visitor Ring Count 12
08 Setting Talk Time 90 seconds
09 Enabling/Disabling Pulse Dial 9 Disabled
10 Enabling/Disabling Call Waiting Disabled
12 Enabling/Disabling Do Not Disturb Schedule Disabled
13 Enabling/Disabling Call Forwarding Disabled
20 Maximum Number of Keypad Errors 5 for Keypad 1
5 for Keypad 2
21 Enabling/Disabling Alarm Call Disabled
23 Setting the Main Gate Activation Time 10 seconds
24 Setting Auxiliary Relay Activation Time 10 seconds
26 Setting Auxiliary Relay and Status Configuration Control relay, exit request 2
29 Rings Before Answer 5
34 Programming Visitor Response Keys 9 5 2 1
✱
36 Programming the Alternate Prefixes Normal
40 Enabling/Disabling Unlock Schedules Disabled
C. ENABLING/DISABLING THE NO-TELCO MODE (STEP 33)
The Telco mode is invoked when the unit is using a telephone line. Enable No-Telco mode when the
unit is not using a telephone line.
Factory Setting : 0 (disabled).
Format 33 + No-Telco mode (1 digit) + “#”
•
The No-Telco mode is one digit long:
0 = Enables Telco mode
1 = Enables No-Telco mode
Example 33 + 1 + #
(enables the No-Telco mode)
NOTE If No-Telco is enabled while a telephone line connected to the unit, the Crown Jewel
ignores the telephone line. All Telco features like call forwarding and call waiting are
disabled.