DT-E 1.3: SUN PROTECTION SCREEN – VENETIAN BLINDS C80P and C80L
Issue 3 / April 2017 / EN
page 55 / 62
5.3.
OPERATION SAFETY
Product can only be used when it is defect-free.
Recommendations and actions:
the product is safe for use as long as the recommendations included in the documentation are observed,
disconnect the product from electrical installation before commencing any work on the building facade, not
connected with the maintenance of the product,
all work connected with inspections and repairs of the product should be carried out by a properly trained person
holding adequate qualifications,
attention should be paid to any signs of wear or damage to electrical cables,
in case signs of wear or damage to electrical cables are found, the product must not be used, the fault should be
reported to supplier immediately,
the remote control appliances should be kept out of the reach of children,
entering and staying in the up-down work area of the product should take place only when it is totally open and
stopped,
while folding and unfolding the product, attention should be paid that no objects or people are present within the
product work area (in the space between the guides and bottom bar),
no warm objects (e.g. irons, heaters etc.) shall be kept in proximity of the fabric.
Forbidden actions:
Do not pull the product and slats up by force. Doing so may result in system damage,
Stay clear of the work area of the slats while the system is working,
It is forbidden to use a product not conforming to the electric shock and fire safety requirements,
It is forbidden to exceed specific work parameters of the product determined in the technical and operational
documentation,
No sharp objects or protruding elements which can hook the bottom bar or slats can be kept near the system,
it is forbidden to use faulty or incomplete product (e.g. without a switch, tightener), using such product may result
in its damage, pose threat to user’s health and life,
It is forbidden to conduct self-repairs,
It is forbidden to use the product and electrical installation without relevant and required inspections and
measurements,
It is forbidden to take off the electric drive casings,
Do not touch the movable elements while folding or unfolding the product. It may result in crushing,
cutting, pulling in, or blocking between, e.g. the bottom bar and the other structural elements of the
system,
Within the work space of the product there should be no obstacles that might interrupt its work or
damage it. In case the product enters an obstacle, first it should be folded slightly and then the obstacle
should be removed,
Stay clear of the work area of the venetian blind while it is working.
Centrally controlled products can activate automatically. Make sure no dangerous situation arises.
SELT Sp. z o. o. shall not be responsible for damage due to improper use.
Operating the system out of one’s sight can result in heavy injuries as well as system damage.
WARNING !
