SELMI ROASTER CENTOVENTI, Инструкция по установке, эксплуатации и обслуживанию

Страница: 27 / 50

27
3.3. Transportation
To transport the machine it is necessary to use a
suitable vehicle equipped with a platform to lift the
load; the platform must be adequate for the weight
of the machine, which is stated in the technical
characteristics section (section 1.13).
When the machine, still in its packaging, is in the
body of the lorry, it can be carried to the lifting
platform only by means of a manual transportation
trolley for euro pallets.
The lifting platform has to be equipped with side rails
in order to prevent the machine from falling when it
is still high off the ground.
The machine can be lowered to the ground from the
platform only after having lowered the manual trolley.
The machine should be lowered slowly from the
platform, avoiding shaking and sudden stops which
could cause a loss of stability.
After having completed the unloading procedures,
the machine should be moved exclusively by means
of a manual transportation trolley adequate for euro
pallets; the platform should only be lifted to the
height needed to move the machine.
Before moving the machine verify that the passage
to the final destination is clear.
Attention
Do not go on very steep ramps which could
cause the loss of control of the trolley.
3.4. Removal of the packaging
Cut the straps that anchor the cardboard to the
platform; remove the cardboard and put it out of the
way.
Cut the straps that hold the machine to the platform,
remove the machine’s plastic cover and unravel the
accessories provided.
Carefully lift the front of the machine and remove the
wooden slat blocking the front wheels; subsequently
remove also the wooden slat blocking the rear
wheels by lifting the back of the machine.
Very carefully lower the machine from the platform.
Note
Keep the original packaging; it may be
necessary to use it if the machine needs to be
sent to the manufacturer for extraordinary
maintenance or repairs.
4. Installation section
4.1. Positioning
Warning
Before positioning the machine check that the
machine, the associated accessories and the
parts supplied separately have not been
damaged during transportation.
It is the task of the Client to make sure that the
strength of the supporting surface, at the point of
installation, is adequate for the weight of the
machine.
The flooring at the point of installation must be
sufficiently level.
Isolate the machine from any potential vibrations
coming from other nearby machinery.
In the case where the machine or any of the
associated accessories are found damaged it is
important to alert the manufacturer of the found
anomaly so as to agree on the actions to be taken.
Attention
The machine must be placed on a level
surface;
for the other environmental
requirements necessary for optimal
functioning of the machine please see
sections 1.11 and
2.5..
4.2. Electrical connections
Attention
The connection of the machine to the
electrical system must be carried out by
personnel observing the legislation in force;
the characteristics of the electrical connection
must be compatible with the electrical
specifications of the machine which can be
found in the relevant section or on the
apposite plaque on the door of the electric
panel.
Attention
If the machine has been purchased to be
powered by a three phase line, make sure that
in the socket there is a connection to the
neutral wire. This is necessary for the
functioning of the machine.
Attention
Before starting any procedure make sure that
there are no objects inside the tank.