Galeo S / Galeo S Sub
7 Installing the line array system
21
Once all the Stop Pin
s are in their appropriate positions, the curve is set by “compressing” the rear
of the array. This can be done by lifting the lowest cabinet by hand or with a hand chain hoist / mo-
tor chain hoist or by placing the array on the floor.
Setting the curve of the Galeo S Arrays by lifting the lowest Galeo S unit
After curving the array, it is vitally important to check that all of the Auto-Locking Hooks have
locked in correctly. This can be easily seen with a visual inspection. If the Auto-Locking Hooks
have set correctly, one of the two hooks on each element will be exactly parallel to the Center Rail.
Should this not be the case, it must be corrected immediately because the load of the lower units is
based on a too small surface of the indexed Center Rail. An incorrectly set auto-locking hook may
lose its hold and slip to a smaller splay angle.
Checking that all of the Auto-Locking Hooks have locked in correctly
