Galeo S / Galeo S Sub
7 Installing the line array system
20
7.4
Mounting addidtional Galeo S units
Additional Galeo S units are mounted to the array following the same principle as for mounting to
the Flying Frame or Cradle (see section 7.2) using the Snap-Fly links at the front and the Center
Link at the rear.
7.5
Setting splay angles and lifting in operation position
When the array is flown, the Stop Pins on the rear of the Galeo S elements, which specify the splay
angles, are not under load. They can be removed from the 0° position and placed in the position
required for the desired splay angle. The uppermost Galeo S unit, which is connected to the Flying
Cradle or Flying Frame, always has a splay angle of 0° for mechanical reasons.
The angles for the rest of the Galeo S units are set by placing the Stop Pin in the hole for the re-
quired splay angle for each element in the Indexed Center Rail of the next highest element. This
should be done for all Galeo S units in the array before the curving is done.
Presetting the desired splay angles in flown, not curved array
