Secutron MR-2605, Руководство по установке

Страница: 42 / 72

Secutron Inc. 42
6.2 Programming and Exiting the System
How to Program the System
1. Enter Installer Programming Mode. For details on how to do so see 6.1 Entering Installer
Programming Mode on page 40.
2. Press the Signal Silence button to select the correct option for the Programmable Function.
3. Press the Silence Trouble button to cycle to the next function.
4. Repeat steps 2-3 until all Programmable Functions are completed. You are now ready to exit
the Installer Programming Mode.
How to Exit the System
1. To exit Installer Programming Mode press the Silence Trouble button.
2. Upon exiting the Installer Programming Mode, the panel performs a system reset for 10
seconds, during which the buzzer sounds double beeps. When the beeping stops the panel
returns to normal operating mode and all programming choices are stored in memory.
6.3 Programming Function Descriptions
6.3.1 Zone Programming
Zone Programming is the first Programmable function. Each of the 5 zones can be configured
as one of the following:
• Instant Alarm
• Waterflow Zone
• Supervisory Zone
• Not Used
Use all 5 Zone Alarm, Supervisory and Trouble LED’s to program this function.
Press the Silence Alarm control to cycle through the programmable settings for each zone.
Press the Silence Trouble control to cycle through the Zones. To proceed to the next
programming function cycle through all 5 zones.
The Trouble LED flashes when the panel is in any Programming Mode.
No other Panel Status LED’s will be lit.
Notes: To exit the Installer Programming Mode at any other point in the panel programming, press and
hold the Walk Test switch for two seconds.
If 5 minutes elapse without any button presses, the panel will automatically exit the Installer
Programming Mode. During the final 60 seconds before the exit, the panel will sound a warning
tone on the buzzer. Press any button to cancel the auto-exit and resume programming.